Different Ways To Use An Access Point
What Is Wireless Access Point:
Wi-Fi access points change the way we need to think what a network is.
Visualizing a network as being a group of computers connected to a hub, router or switch by Ethernet cables, is like imaging how we used typewriters.
With the introduction of the 802.11 wireless standards computers don’t require cables anymore to be part of a network; they just need to be in range.
Being in range is where the wireless access point comes into play, and WHNME will help you understand how it changes the fundamentals of computer networks.
What Is Wireless Access Point
What is wireless access point:
A wireless access point is a piece of wireless enabled network equipment that receives and transmits wireless Ethernet packets from a wired network from computers already connected to it.
When you Set Up Wireless Access Point, you’ll see that the main function is to receive and direct login requests to the to the acting DHCP server or domain controller for authentication who are not.
How do wireless access points work:
Wireless access points perform a technique called “Modulation” to transfer data it receives in or out of the access point.
The modulation process works in both directions depending on which way the data is traveling.
The Wi-Fi access point takes the modulated radio frequency voltages highs and lows transmitted from a nearby wireless network card, and turns these high and low voltage signals into 1’s and 0’s instead.
The binary 1’s and 0’s, then get assembled in to Ethernet packets and forwarded to the wireless router, and then across the network to the destination IP address for delivery.
What is wireless access point effect the network:
There is no real affect on the base router, because of the wireless access point being introduced to the network.
The WAP is only seen to the router as another IP address on the network.
If there is any performance decrease to the network, it’s mostly felt on the wireless side of the access point, because today’s wireless home network routers are built using 4 port switches.
Older legacy hubs and routers used a “shared bus” technology, meaning that all the ports on the hub or router shared the load coming through it.
Switches use a “switching technology”, that allows port 1 to talk to port 4 without effecting ports 2 or 3, and so on. This greatly increases the network flow when needing to route packets on the network.
How can wireless access points be used:
Wireless access points depending on the model can be used in several ways.
The WAP can be configured as a “Standard Wireless Access Point” connected to a router with an Ethernet cable, allowing wireless networks to enter and leave the network.
It can be configured as a “Wireless Repeater” connecting to the base router via radio signals to repeat and extend the range of the network.
And, it can also be configured as a “Wireless Bridge” connecting to completely separate networks via the wireless signal, and pass Ethernet packets from one network to the next.
That’s it! Regardless of how you decide to configure and implement what is wireless access point to your home network, it’s not hard imagine how these high tech and innovative devices can change the effective range, method and dynamics of your wireless network.